Circuit Description
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1998 GMC Yukon, 1998 GMC Suburban, 1998 GMC Pickup, 1998 GMC Cab & Chassis, and 1998 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
Rear drive shaft speed sensors are a permanent magnet (PM) generator. Sensors produce a pulsing AC voltage. AC voltage level and number of pulses increases as speed increases. ATC control module converts pulsating AC voltage to drive shaft RPM which is used for calculations and to monitor difference between front and rear drive shaft speed. Drive shaft RPM can be displayed using scan tool. ATC control module only monitors this signal when vehicle is in 2H position. DTC C0300 detects open, short to ground or faulty sensor.