4.3L "C" & "K" Series: Removal
WARNING: This page is about a different variant/trim than selected.
- Disconnect the battery negative cable. Remove the oil level indicator. Raise the vehicle.
- Remove the engine oil and the engine oil filter. Remove the oil filter adapter. Refer to OIL FILTER ADAPTER .
- Remove the starter motor. Remove the transmission cover.
- Remove the oil cooler pipes and the retainer from the side of the engine.
- Remove the transmission. Refer to REMOVAL & INSTALLATION ("C" & "K" SERIES) .
- Remove the engine flywheel.
- Remove the access plugs for the oil pan rear nuts. Remove the oil pan nuts and bolts.
- Remove the ten oil pan bolts.
- Remove the two nuts at the crankshaft rear oil seal.
- Remove the transmission to oil pan bolts.
- Remove the engine oil pan and the oil pan gasket.
Clean all sealing surfaces.