LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1998 >> C3500 HD 6.5 F, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 4.3L V6, 5.0L, 5.7L & 7.4L V8 - VINS [W,X,M,R,J]) >> Removal & Installation >> Cooling System Bleeding

Cooling System Bleeding

WARNING: This page is about a different variant/trim than selected.
  1. Fill radiator to base of filler neck. Start engine. Place A/C-heater control in any position except MAX. Select highest temperature setting. Idle engine until lower radiator hose is hot.
  2. Increase engine speed to 3000 RPM and then back to idle. Do this 5 times to expel any air trapped in system. Fill radiator as necessary. Install radiator cap. Allow engine to cool. Fill coolant recovery reservoir as necessary.
  3. Crush and add 2 Coolant Sealant Pellets (GM P/N 3634621) or equivalent to radiator (if reservoir is not pressurized) or coolant reservoir (if reservoir is pressurized).
scientia non olet · About LEMON Manuals