LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1997 >> Jimmy 4D Utility, RWD >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension - Torsion Bar (4WD) >> Removal & Installation >> Upper Control Arm Bushings >> Bushing Replacement

Bushing Replacement

  1. Remove upper control arm from vehicle. See UPPER CONTROL ARM . Place upper control arm in soft-jawed vise.
  2. Press bushings out of upper control arm using Nut (J-21474-18), Bolt (J-21474-19), washer, bearing and Control Arm Bushing Service Set (J-33793). See Fig 1.
  3. Install NEW bushings into upper control arm using Nut (J-21474-18), Bolt (J-21474-19), washer, bearing and Control Arm Bushing Service Set (J-33793). See Fig 1.
  4. Ensure bushings are properly seated in upper control arm. Install upper control arm. See UPPER CONTROL ARM .
Fig 1: Replacing Upper Control Arm Bushings
G92J21898Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals