LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1997 >> Forward Control 4.3 W, L35, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Instrument Panel (G Series)) >> System Tests >> Temperature Gauge Always Indicates Hot

Temperature Gauge Always Indicates Hot

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1997 GMC Savana Special, 1997 GMC Savana Camper Special, 1997 GMC Savana, 1997 Chevrolet RV Cutaway, and 1997 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Warm engine to normal operating temperature. Compare engine temperature with coolant gauge reading. If readings are within 30 degrees of each other, gauge is operating properly. Check cooling system. If readings are not within 30 degrees of each other, go to next step.
  2. Disconnect coolant temperature sender harness connector. Turn ignition switch to RUN position. If temperature gauge indicates COLD, replace temperature sender. If gauge does not indicate COLD, go to next step.
  3. Disconnect instrument cluster harness connector. Connect self-powered test light between ground and harness connector terminal No. B9 (Dark Green wire). If test light does not light, replace instrument cluster. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION. If test light lights, repair open in Dark Green wire.