LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1997 >> C3500 HD 7.4 J, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Engine Mechanical - 4.3L V6 - VIN W & ,X) >> Removal & Installation >> Rear Crankshaft Oil Seal >> Installation

Rear Crankshaft Oil Seal: Installation

WARNING: This page does not describe the selected car, but rather 24 other vehicles, including the 1997 Oldsmobile Bravada, 1997 GMC Sonoma, 1997 GMC Savana, 1997 GMC Safari, and 1997 GMC Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate inner and outer diameter of seal with engine oil. Place seal on Seal Installer (J-35621). Position seal against crankshaft as indicated in illustration. See Fig 1.
  2. Thread attaching screws into crankshaft flange and tighten with screwdriver. This squares seal with crankshaft. Rotate seal installer handle until it bottoms. Remove seal installer. Install flywheel, clutch (M/T) and transmission.
Fig 1: Installation Position Of Rear Crankshaft Oil Seal.
G97I03615Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals