LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1997 >> C3500 HD 6.5 F, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Engine Mechanical - 4.3L V6 - VIN W & ,X) >> Removal & Installation >> Cylinder Head >> Installation

Cylinder Head: Installation

WARNING: This page does not describe the selected car, but rather 24 other vehicles, including the 1997 Oldsmobile Bravada, 1997 GMC Sonoma, 1997 GMC Savana, 1997 GMC Safari, and 1997 GMC Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean gasket surfaces, bolt threads and bolt holes. If using steel head gasket, thinly coat both sides of gasket with sealant. DO NOT apply sealant to composite (steel/asbestos) head gaskets. Position head gasket on cylinder block. Ensure all holes align. Coat head bolt threads with GM Sealant (1052080).
  2. Install cylinder head with bolts finger-tight. Tighten head bolts in sequence to specification. See Fig 1. See TORQUE SPECIFICATIONS  table. Lubricate valve tip, rocker arm pivot and push rod socket with Molykote.
  3. To complete installation, reverse removal procedure. Adjust valves. See VALVE CLEARANCE ADJUSTMENT  under ADJUSTMENTS.
Fig 1: Cylinder Head Bolt Tightening Sequence
G95B27053Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals