LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1996 >> Jimmy 2D Utility, 4WD, Automatic >> Repair and Diagnosis >> Suspension >> Front Suspension >> Suspension - Front Torsion Bar (4WD) >> Torque Specifications

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Ball Joint-To-Control Arm Nut (1) 17 (23)
Ball Joint-To-Steering Knuckle Nut (1)(2)
Lower 79 (107)
Upper 61 (83)
Drive Axle Shaft Nut 181 (245)
Hub & Bearing/Shield-To-Steering Knuckle Bolt 77 (105)
Lower Control Arm-To-Frame Pivot Bolt (1)(5) 81 (110)
Lower Control Arm-To-Frame Pivot Bolt Nut (1)(3)(5) 81 (110)
Shock Absorber Nut (4) 54 (73)
Stabilizer Bar Clamp-To-Frame Bolt 26 (35)
Stabilizer Bar-To-Lower Control Arm Bolt 11 (15)
Tie Rod End-To-Steering Knuckle Nut 39 (53)
Torsion Bar Retainer-To-Support Link Nut
Lower 50 (68)
Upper 33 (48)
Upper Control Arm-To-Frame Pivot Bolt Nut (1)
Front 85 (115)
Rear 72 (98)
Wheel Lug Nut 95 (129)
(1) Complete tightening of bolts and/or nuts with vehicle at proper riding height specification.
(2) Tighten nut to align cotter pin hole. DO NOT tighten nut more than an additional 1/6 turn to align cotter pin hole.
(3) Use NEW nuts during reassembly.
(4) Install both bolts with nuts facing rear of vehicle.
(5) Install upper/rear bolt with nut facing rear of vehicle. Install lower/front bolt with nut facing front of vehicle.