Bushing Replacement
- Remove upper control arm from vehicle. See UPPER CONTROL ARM
. Place upper control arm in soft-jawed vise.
- Press bushings out of upper control arm using Nut (J-21474-18
), Bolt (J-21474-19
), washer, bearing and Control Arm Bushing Service Set (J-33793
). See Fig 1
.
- Install NEW bushings into upper control arm using Nut (J-21474-18
), Bolt (J-21474-19
), washer, bearing and Control Arm Bushing Service Set (J-33793
). See Fig 1
.
- Ensure bushings are properly seated in upper control arm. Install upper control arm. See UPPER CONTROL ARM
.
Courtesy of GENERAL MOTORS CORP.