Daytime Running Lamps (DRL) Are Operational At All Times
- Turn ignition switch to RUN. If daytime running lights (DRL) indicator is lit, go to next step. If daytime running lights (DRL) indicator is not lit, go to step 4).
- Disconnect DRL module. If DRL indicator is lit, go to next step. If DRL indicator is not lit, replace DRL module.
- Disconnect instrument cluster printed circuit connector. If DRL disables, replace instrument cluster. If DRL does not disable, service/repair short to ground in Light Green/Black wire between instrument cluster printed circuit and convenience center.
- Remove DRL relay from convenience center. If DRL disables, replace DRL relay. If DRL does not disable, service/repair short to voltage in Tan wire between convenience center and left Hi/Lo beam headlamp (Base Headlamps) and left high beam headlamp (Quad Headlamps).