LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1995 >> Yukon 4D Utility >> Repair and Diagnosis >> Suspension >> Front Suspension >> Suspension - Front Torsion Bar (4WD) >> Torque Specifications

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Ball Joint-To-Control Arm Nut (1)
Lower 44 (60)
Upper
K1500/K2500 17 (23)
K3500 52 (70)
Ball Joint-To-Steering Knuckle Nut (1)(2)
Lower 94 (128)
Upper 85 (115)
Drive Axle Shaft Nut 173 (235)
Drive Axle Shaft-To-Differential Drive Flange Bolt 59 (80)
Hub & Bearing-To-Steering Knuckle Bolt 133 (180)
Lower Control Arm-To-Frame Pivot Bolt Nut (1)(3)(4) 136 (185)
Shock Absorber Nut (5) 66 (90)
Splash Shield Bolt 19 (26)
Stabilizer Bar Clamp-To-Frame Bolt 24 (33)
Stabilizer Bar Spacer Nut 17 (23)
Tie Rod End-To-Steering Knuckle Nut 40 (54)
Torsion Bar Retainer-To-Support Nut
Center Nut 18 (24)
Edge Nut 46 (62)
Upper Control Arm-To-Frame Pivot Bolt Nut (1)(3) 140 (190)
(1) Complete tightening of bolts and/or nuts with vehicle at proper riding height specification.
(2) Tighten nut to align cotter pin hole. DO NOT tighten nut more than an additional 1/6 turn to align cotter pin hole.
(3) Use NEW nuts during reassembly.
(4) Install both bolts with nuts facing rear of vehicle.
(5) Install upper/rear bolt with nut facing rear of vehicle. Install lower/front bolt with nut facing front of vehicle.