LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1995 >> Yukon 4D Utility >> Repair and Diagnosis >> Suspension >> Front Suspension >> Suspension - Front Torsion Bar (4WD) >> Removal & Installation >> Upper Control Arm Bushings >> Bushing Replacement

Bushing Replacement

  1. Remove upper control arm from vehicle. See procedures under UPPER CONTROL ARM  . Place upper control arm in soft-jawed vise.
  2. Press bushings out of upper control arm.
    NOTE: Alignment angles are preset at factory. Knockouts MUST be removed before installation of alignment adjustment cams using Knockout Removal Tool (J-38794 ).
  3. Press NEW bushings into upper control arm.
  4. Ensure bushings are properly seated in upper control arm. Install upper control arm. See UPPER CONTROL ARM  .
scientia non olet · About LEMON Manuals