Mechanical - Hydraulic: Drum: Remove & Replace
WARNING: This page is about the Rally G2500, 4.3 Z, which is a different variant/trim than selected.
Includes: Repack Wheel Bearings on Full Floating Axles.
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| G2500, Rear,Both,Full Floating Axle,Inboard Mounted,Separable | 2.2 | B | ||
| G2500, Rear,Both,Full Floating Axle,Non Separable | 1.8 | B | ||
| G2500, Rear,Both,Full Floating Axle,Outboard Mounted,Separable | 1.8 | B | ||
| G2500, Rear,Both,Semi-Floating Axle | 0.5 | B | ||
| G2500, Rear,One Side,Full Floating Axle,Inboard Mounted,Separable | 1.2 | B | ||
| G2500, Rear,One Side,Full Floating Axle,Non Separable | 1.0 | B | ||
| G2500, Rear,One Side,Full Floating Axle,Outboard Mounted,Separable | 1.0 | B | ||
| G2500, Rear,One Side,Semi-Floating Axle | 0.3 | B | ||
| Additional Procedure: DRUM: Remove & Replace: | ||||
| w/10 Stud Wheels add (Each) | 0.2 | B | ||
| w/Separable Hub add (Each) | 0.1 | B | ||
| Combination Procedure: DRUM (REMOVED): Refinish: NOTE: Estimates listed is for 3 inch width or smaller. For each additional inch add .1. DOES NOT include grind hot spots. | ||||
| Each Additional | 0.2 | B | ||
| One | 0.3 | B | ||
| Combination Procedure: OIL SEAL WEAR SLEEVE: Replace: | ||||
| Each | 0.2 | B | ||