Wheel Cylinder: Remove & Replace
WARNING: This page is about the Rally G2500, 4.3 Z, which is a different variant/trim than selected.
Includes: Repack Wheel Bearings (where applicable), bleed System and replace Shoes (if necessary).| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| G2500, Rear,Both,Full Floating Axle | 2.4 | 1.8 | B | |
| G2500, Rear,Both,Semi-Floating Axle | 1.8 | 1.1 | B | |
| G2500, Rear,One Side,Full Floating Axle | 1.3 | 1.0 | B | |
| G2500, Rear,One Side,Semi-Floating Axle | 1.0 | 0.8 | B | |
| Additional Procedure: WHEEL CYLINDER: Remove & Replace: | ||||
| w/Rear Wheel ABS,add | 0.8 | B | ||
| Combination Procedure: OIL SEAL WEAR SLEEVE: Replace: | ||||
| Each | 0.2 | B | ||