LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1995 >> Jimmy 4D Utility, AWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brake System & Drum Brake System - "S" & "T" Series >> Removal & Installation >> Front Brake Rotor >> Installation

Front Brake Rotor: Installation

  1. Clean and pack wheel bearings. Install rotor and hub assembly. Install outer bearing, washer and nut. Tighten nut to 12 ft. lbs. (16 N.m) while rotating rotor and hub assembly. This seats bearings.
  2. Back off nut until it just begins to loosen. Finger-tighten nut. Back off nut until hole in spindle aligns with hole in nut (DO NOT  back off more than 1/2 of a flat). Install new cotter pin, bend ends over and ensure ends will not contact grease cap when installed. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals