Removal & Installation
WARNING: This page is about a different car, the 1995 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Vehicle Speed Sensor (VSS) is located in left rear of transmission. Ensure ignition is off. Raise and support vehicle. Disconnect VSS electrical connector. Place a container under VSS mounting area to catch transmission fluid when VSS is removed.
- Remove VSS mounting bolt. Using J-38417, remove VSS and"O" ring. To install, coat NEW "O" ring with transmission fluid. Install "O" ring onto VSS. Install VSS and "O" ring into transmission using J-38417. Install mounting bolt through VSS bracket.