LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1995 >> Jimmy 2D Utility, 4WD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Anti-Lock Brake System - Rear (2.2L)) >> Removal & Installation >> Electronic Brake Control Module >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 1995 GMC Sonoma. However, it is still accessible from the selected car via links, so may be relevant.
  1. EBCM is located next to master cylinder. Ensure ignition is off. Disconnect electrical connectors from EBCM. Pry tab at end of EBCM by pulling tab toward front of vehicle. Remove EBCM.
  2. If brake fluid does contact EBCM connectors (vehicle harness connectors), rinse with water and then rinse with denatured alcohol. To install, slide EBCM into bracket until tab locks into hole. Connect EBCM electrical connectors.
scientia non olet · About LEMON Manuals