LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1995 >> Jimmy 2D Utility, 4WD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Anti-Lock Brake System - Rear (2.2L)) >> Diagnosis >> Brake Light Off

Brake Light Off

WARNING: This page is about a different car, the 1995 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Perform SYSTEM DIAGNOSTIC CHECK  before performing trouble shooting procedure.
  1. Ensure parking brake is released. Turn ignition off and then on. Check BRAKE indicator light. If BRAKE light comes on and then goes off after 2 seconds, go to INTERMITTENT BRAKE LIGHT . If BRAKE light is not on, go to next step.
  2. Apply parking brake. If BRAKE light comes on, go to next step. If BRAKE light does not come on, check brake light bulb. If bulb is okay, repair open in BRAKE light circuit. Perform procedures under SYSTEM DIAGNOSTIC CHECK .
  3. Turn ignition off. Release parking brake. Disconnect EBCM 6-pin connector. Connect jumper between Tan/White wire and Black wire terminals of EBCM 6-pin connector. Turn ignition on. If BRAKE light comes on, replace EBCM. After EBCM replacement, perform procedures under SYSTEM DIAGNOSTIC CHECK . If BRAKE light does not come on, go to next step.
  4. Turn ignition off. Connect jumper between Tan/White wire terminal of EBCM 6-pin connector and a known good ground. If BRAKE light comes on, repair open in EBCM ground (Black wire) circuit. Perform SYSTEM DIAGNOSTIC CHECK . If BRAKE light does not come on, repair open in brake light (Tan/White wire) circuit. Perform procedures under SYSTEM DIAGNOSTIC CHECK .
scientia non olet · About LEMON Manuals