Bleeding Brake System
WARNING: This page is about a different car, the 1995 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
Bleed base brake system, using manual or pressure bleeding procedure. See the BRAKE SYSTEM article. Connect Tech 1 scan tester with RWAL/4WAL cartridge or Mass Storage Cartridge to Data Link Connector (DLC). Turn ignition on. Perform 3 RWAL functional tests. Re-bleed rear brakes. Ensure there is no sponginess in brake pedal. Repeat bleed procedure if necessary.