LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1995 >> Forward Control 4.3 Z, Standard >> Repair and Diagnosis >> Suspension >> Front Suspension >> Suspension - Front (Coil Spring) >> Adjustments >> Front Wheel Bearings

Front Wheel Bearings

CAUTION: Never preload tapered roller bearings, or damage to bearings will result. Bearings are designed to have a slightly loose feel when properly adjusted.
  1. Raise and support vehicle. Remove hub dust cap and cotter pin. Tighten spindle nut to 12 ft. lbs. (16 N.m) while turning wheel forward by hand. Back off nut until just loose.
  2. Finger-tighten nut until snug. Loosen nut slightly (no more than 1/2 flat) until new cotter pin can be installed. Install new cotter pin. Measure hub end play. Hub end play (in and out) should be .001-.005" (.03-.13 mm) when properly adjusted. Install dust cap.
scientia non olet · About LEMON Manuals