Forward & Direct Clutch

Apply air pressure into center support hole to hold intermediate clutch plates in place. Using Clutch Installer (J-38733), install direct clutch assembly and front band. See Figure and Fig 1. Using Clutch Installer (J-38358-A), install forward clutch assembly and thrust bearing. See Fig 2 and Figure.

NOTE: Check installed height of speed sensor ring (on forward clutch housing). Top of speed sensor ring to oil pump gasket surface height should be 3.85-3.89" (98.0-99.0 mm).

Fig 1: Installing Direct Clutch

Courtesy of GENERAL MOTORS CORP.

Fig 2: Installing Forward Clutch

Courtesy of GENERAL MOTORS CORP.