LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1995 >> Forward Control 4.3 Z, Standard >> Repair and Diagnosis (Single Page) >> Suspension >> Front Suspension >> Suspension - Front (Coil Spring) >> Removal & Installation >> Wheel Hub/Rotor & Bearings >> Removal

Wheel Hub/Rotor & Bearings: Removal

  1. Raise and support vehicle. Remove wheel and tire assembly. Remove brake caliper and hang aside with wire. DO NOT allow brake caliper to hang by brakeline.
  2. Remove dust cap, cotter pin, spindle nut and washer. Carefully remove hub/rotor assembly to avoid damage to spindle threads. Remove outer bearing, inner grease seal and inner bearing.
  3. Clean bearings, and inspect bearings and races for damage. If races require removal from hub, drive old races from hub using a hammer and a brass drift inserted through notches of hub.
scientia non olet · About LEMON Manuals