LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1995 >> Forward Control 4.3 Z, Standard >> Repair and Diagnosis (Single Page) >> Steering >> Steering Column - P Series Van >> Removal & Installation >> Steering Wheel & Horn Pad (With Air Bag) >> Removal

Steering Wheel & Horn Pad (With Air Bag): Removal

  1. Disable air bag system. See AIR BAG DISABLING  . Inflator module is located on steering wheel hub. Remove screws from underside of steering wheel.
  2. Partially remove inflator module. Disconnect steering wheel inflator module connector, CPA clip and horn contact from inflator. Remove inflator module.
  3. Position steering wheel straight ahead. Remove snap ring and steering wheel retaining nut. Mark steering wheel and shaft for reassembly reference. Using Steering Wheel Puller (J-1859-03), remove steering wheel.
CAUTION: To prevent damage to canceling cam and switch assembly, turn signal switch must be in neutral position before steering wheel is installed.
scientia non olet · About LEMON Manuals