LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1995 >> Forward Control 4.3 Z, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Servicing >> HARRISON Hr100T & Hr110-MD 4-Cylinder >> Belt Pulley >> Removal ("V" Groove Belt Pulley)

Removal ("V" Groove Belt Pulley)

  1. Remove clutch plate. See CLUTCH PLATE. Remove pulley assembly snap ring. Install Pulley Rotor and Puller Guide (J-25031) to pulley assembly. Install Pulley Rotor and Bearing Puller (J-33020) down into inner circle of slots in pulley assembly.
  2. Turn puller clockwise to engage puller tangs with segments between pulley assembly slots. Tighten puller center screw against puller guide to remove pulley assembly from compressor.
  3. Scribe reference marks on compressor and clutch coil for installation reference. Install Pulley Rotor and Puller Guide (J-25031) to pulley assembly. Using a 2-jaw puller, remove clutch coil from front head of compressor.
scientia non olet · About LEMON Manuals