LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1995 >> Forward Control 4.3 Z, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Servicing >> HARRISON Hd6/Hr6-He 6-Cylinder & V5 5-Cylinder >> Shaft Seal >> Removal

Shaft Seal: Removal

  1. Discharge A/C system using approved refrigerant recovery/recycling equipment. Using Clutch Plate Spanner (J-25030 for HD6/HR6-HE compressor or J-33027-A for V5 compressor), hold clutch plate and remove compressor shaft nut. Thread Clutch Plate Remover/Installer (J-33013-B) into clutch plate, and remove clutch plate. See Figure or Figure.
  2. Remove shaft seal snap ring. Ensure all surfaces around seal are clean. Install Shaft Seal Protector (J-34614) over compressor shaft. Insert Shaft Seal Remover/Installer (J-23128-A) into shaft seal.
  3. Rotate handle clockwise to seat seal remover/installer in seal. Remove shaft seal. Using "O" Ring Remover (J-9553-01), remove "O" ring.
scientia non olet · About LEMON Manuals