HARRISON Hd6/Hr6-He 6-Cylinder, Hr100T & Hr110-MD 4-Cylinder, & V5 5-Cylinder
- Operate system for several minutes to stabilize system, if possible. Turn engine off. Discharge A/C system using approved refrigerant recovery/recycling equipment. Remove compressor. Drain refrigerant oil through compressor drain plug and measure oil.
- If no oil leaks exist and more than one ounce is drained, add drained amount using new oil. If less than one ounce is drained, add 2 ounces of new oil.
- If replacing A/C components, add specified amount of refrigerant oil to system. See HD6/HR6-HE, HR100T, HR110-MD & V5 COMPONENT REFRIGERANT OIL CAPACITIES table. Install drain plug and compressor. Evacuate and recharge system. Perform leak test.
NOTE:
Approximately 3 ounces of refrigerant oil, suspended in refrigerant, will be lost due to a large, abrupt leak. When replacing faulty component, add required amount of oil for component plus 3 ounces of oil to component. If oil cannot be easily added to component, add to accumulator/receiver-drier.
HD6/HR6-HE, HR100T, HR110-MD & V5 COMPONENT REFRIGERANT OIL CAPACITIES
| Component | Ounces | |||
|---|---|---|---|---|
| Accumulator/Receiver-Drier | ||||
| "G" Body | 3.5 | |||
| Except "G" Body | (1) | |||
| Condenser | 1.0 | |||
| Evaporator | 3.0 | |||
| "U" Body | ||||
| Rear Evaporator | 2.0 | |||
| Rear Evaporator Lines | 1.0 | |||
|
||||