LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1995 >> Forward Control 4.3 Z, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Mechanical 6.5L Turbo Diesel - VIN [F] >> Removal & Installation >> Hydraulic Valve Lifters >> Removal

Hydraulic Valve Lifters: Removal

  1. Remove intake manifold. See INTAKE MANIFOLD  . Remove rocker arm assembly. See ROCKER ARM ASSEMBLY  .
  2. Remove guide plate clamps and guide plates through access holes in cylinder head using mechanical fingers. Remove lifters using Lifter Remover (J-29834) and magnet. Mark lifter location.
NOTE: Some engines are equipped with standard size and .010" (.25 mm) oversize diameter lifters. Bores fitted with oversize lifters are identified by O.S. stamped on cylinder block pad, adjacent to lifter bore, and on top rail of cylinder case, above lifter bore. Oversize lifters are identified by a number 10 stamped on side of lifter.
scientia non olet · About LEMON Manuals