LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1995 >> Forward Control 4.3 Z, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Mechanical 4.3L V6 - VIN [Z] >> Removal & Installation >> Balance Shaft (4.3L - If Equipped) >> Removal

Balance Shaft (4.3L - If Equipped): Removal

  1. Remove radiator. Discharge A/C system (if equipped) using approved refrigerant recovery/recycling equipment and remove A/C condenser (if equipped) and grille. Remove valve lifters. Refer to VALVE LIFTERS .
  2. Remove timing chain and camshaft sprocket. Refer to TIMING CHAIN & SPROCKETS . Remove balance shaft gears. Remove balance shaft retainer plate.
  3. Remove intake manifold. See INTAKE MANIFOLD . Using a soft-faced hammer, tap balance shaft out toward front of engine.
    NOTE: Front bearing is removed with balance shaft. Replace front bearing and balance shaft as a set only. Replace balance shaft timing gears as a set only.
scientia non olet · About LEMON Manuals