LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1995 >> Forward Control 4.3 Z, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc Brake System & Drum Brake System - P Series Van >> Removal & Installation >> Rear Brake Rotor >> Removal (11" Full-Floating Axle)

Removal (11" Full-Floating Axle)

  1. Raise and support vehicle. Remove brake caliper (DO NOT disconnect brake hose). See REAR BRAKE CALIPER  under REMOVAL & INSTALLATION. Remove bolts from end of axle shaft. See Figure.
  2. Lightly tap axle shaft flange with soft hammer to loosen shaft. Grip rib on axle shaft flange with locking pliers. Twist axle shaft to start shaft removal. Pull axle shaft from axle housing.
  3. Bend lock washer tab away from lock nut. Using Wheel Bearing Nut Wrench (J-2222-C), remove lock nut. Remove lock washer. Remove adjusting nut and washer. Remove hub and rotor assembly.
scientia non olet · About LEMON Manuals