LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1995 >> Forward Control 4.3 Z, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc Brake System & Drum Brake System - P Series Van >> Removal & Installation >> Rear Brake Rotor >> Installation

Rear Brake Rotor: Installation

  1. Install hub and rotor assembly. Install washer and adjusting nut. Using Wheel Bearing Nut Wrench (J-2222-C), tighten adjusting nut to 50 ft. lbs. (68 N.m) while turning hub and rotor assembly.
  2. Back off adjusting nut and tighten to 30-40 ft. lbs. (41-54 N.m) while turning hub and rotor assembly. Back off adjusting nut 135-150 degrees. Install lock washer and lock nut finger tight. Bend lock washer tab over adjusting nut flat at a minimum angle of 30 degrees.
  3. Tighten lock nut to 65 ft. lbs. (88 N.m) minimum. Bend lock washer tab over lock nut flat at a minimum angle of 60 degrees. To install remaining components, reverse removal procedure.
Fig 1: Exploded View Of Rear Axle Shaft, Hub & Rotor Assembly (Full-Floating Axle)
G95D27105Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals