LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1995 >> Forward Control 4.3 Z, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc Brake System & Drum Brake System - P Series Van >> Removal & Installation >> Rear Axle Hub Bearings & Oil Seal (Full-Floating Axle) >> Removal (11" Axle With Disc Brakes)

Removal (11" Axle With Disc Brakes)

  1. Remove rear hub and rotor assembly. See REAR BRAKE ROTOR  under REMOVAL & INSTALLATION. Using a long drift and hammer, drive out inner bearing race, inner bearing and oil seal from outboard to inboard side of hub. See Figure.
  2. Remove retaining ring from inside of hub, inboard of outer bearing. Using Handle (J-8092) and Outer Bearing Race Remover/Installer(J-24426), drive out outer bearing race from outboard to inboard side of hub.
scientia non olet · About LEMON Manuals