LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1995 >> Forward Control 4.3 Z, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc Brake System & Drum Brake System - P Series Van >> Removal & Installation >> Rear Axle Hub Bearings & Oil Seal (Full-Floating Axle) >> Removal (10 1/2" & 11" Axle With Drum Brakes)

Removal (10 1/2" & 11" Axle With Drum Brakes)

  1. Remove rear hub and drum assembly. See REAR BRAKE DRUM  under REMOVAL & INSTALLATION. Using a long drift and hammer, drive out inner bearing race, inner bearing and oil seal from outboard to inboard side of hub. See Figure.
  2. Remove retaining ring from inside of hub, inboard of outer bearing. Using Handle (J-8092) and Outer Bearing Race Remover/Installer (J-24426), drive out outer bearing race from outboard to inboard side of hub.
scientia non olet · About LEMON Manuals