LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1993 >> Forward Control 7.4 N >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 6.2L V8 Diesel - VIN [C] >> Overhaul >> Cylinder Block Assembly >> Thrust Bearing

Thrust Bearing

  1. Main bearing No. 3 is thrust bearing. Tighten all other main bearing caps to specification. See TORQUE SPECIFICATIONS  table. Tighten thrust bearing to 10 ft. lbs. (14 N.m). Tap crankshaft rearward then forward.
  2. Tighten thrust bearing cap to specification. Measure crankshaft end play at front face of thrust bearing. If crankshaft end play is not .004-.010" (.10-.25 mm), replace thrust bearing or crankshaft.
scientia non olet · About LEMON Manuals