LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1993 >> Forward Control 7.4 N >> Repair and Diagnosis (Single Page) >> Suspension >> Front Suspension >> Suspension - Front Leaf Spring (2WD) >> Removal & Installation >> Steering Arm, Knuckle & Kingpin >> Installation

Steering Arm, Knuckle & Kingpin: Installation

  1. Install NEW kingpin bushings. Ream bushings to 1.1804-1.1820" (29.982-30.023 mm). Lubricate thrust bearing. Install steering knuckle, thrust bearing, shim and dust seal. Lubricate kingpin.
  2. Install kingpin and spacers. Install lock pin, washer and nut. Install gaskets, kingpin caps, brake line bracket, washers and bolts into steering knuckle. To complete installation, reverse removal procedure.
  3. Tighten bolts and nuts to specification. See TORQUE SPECIFICATIONS  table. Lower vehicle and check wheel alignment. See WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT.
scientia non olet · About LEMON Manuals