Bushing Replacement (G15/1500 & G25/2500)

1. Remove upper control arm from vehicle. See UPPER CONTROL ARM . Place upper control arm in soft-jawed vise. Remove nuts from ends of pivot shaft. Using components from Control Arm Bushing Service Set (J-24435-A ), remove bushing from control arm. See Fig 1.
2. Remove pivot shaft from control arm. Note direction of shaft installation. Repeat procedure to remove remaining bushing. Reverse removal order to install bushings. See Fig 2. Ensure bushings are fully seated.

Fig 1: Removing Upper Control Arm Bushing (G15/1500 & G25/2500)

Courtesy of GENERAL MOTORS CORP.

Fig 2: Installing Upper Control Arm Bushing (G15/1500 & G25/2500)

Courtesy of GENERAL MOTORS CORP.