LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1993 >> Forward Control 7.4 N >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Drive Axle - DANA 9.75", 10.5" & 11" (Full-Floating) >> Removal & Installation >> Pinion Flange & Pinion Seal >> Installation

Pinion Flange & Pinion Seal: Installation

  1. Inspect pinion flange. Replace pinion flange if damaged. Lubricate seal.
  2. Using Pinion Seal Installer (D-163 ), drive oil seal into housing bore. Install a non-hardening sealer to pinion splines or to internal splines of pinion flange.
  3. Install washer (if equipped) and self-locking nut to pinion, and snug tighten. Using pinion flange holder and remover, hold pinion flange and tighten pinion nut to proper specifications. See TORQUE SPECIFICATIONS  table. Add lubricant.
scientia non olet · About LEMON Manuals