LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1993 >> C3500 HD 6.5 F, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Suspension - Front (4WD & AWD Torsion Bar)) >> Torque Specifications >> "K" Series Blazer & Pickup, Sierra, Suburban & YUKON

"K" Series Blazer & Pickup, Sierra, Suburban & YUKON

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 1993 Oldsmobile Bravada, 1993 GMC Yukon, 1993 GMC Suburban, 1993 GMC Sonoma, and 1993 GMC Safari. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS ("K" SERIES BLAZER & PICKUP, SIERRA, SUBURBAN & YUKON)

Application Ft. Lbs. (N.m)
Ball Joint-To-Control Arm Nuts (5)
Lower 45 (60)
Upper
K15 & K25 Series Pickup & Sierra, Suburban & Yukon 17 (23)
K35 Series Pickup & Sierra 52 (70)
Ball Joint-To-Steering Knuckle Nut (1)(5)
Lower 94 (128)
Upper 84 (115)
Drive Axle Shaft Nut 173 (234)
Drive Axle Shaft-To-Differential Drive Flange Bolts 60 (80)
Hub & Bearing-To-Steering Knuckle Bolts 133 (180)
Lower Control Arm-To-Frame Pivot Bolt Nuts (2)(3)(5) 135 (185)
Shock Absorber Nuts (4) 66 (89)
Splash Shield Bolts 19 (26)
Stabilizer Bar Clamp-To-Frame Bolts 13 (18)
Stabilizer Bar Spacer Nut 12 (16)
Tie Rod End-To-Steering Knuckle Nut 35 (47)
Torsion Bar Retainer-To-Support Nuts
Center Nut 18 (24)
Edge Nuts 46 (62)
Upper Control Arm-To-Frame Pivot Bolt Nuts (2)(5) 139 (188)
(1) Tighten nut to align cotter pin hole. DO NOT tighten nut more than an additional 1/6 turn to align cotter pin hole.
(2) Use NEW nuts during reassembly.
(3) Install both bolts with nuts facing rear of vehicle.
(4) Install upper/rear bolt with nut facing rear of vehicle. Install lower/front bolt with nut facing front of vehicle.
(5) Complete tightening of bolts and/or nuts with vehicle at proper riding height specification.