LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1993 >> C3500 HD 6.5 F, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Suspension - Front (4WD & AWD Torsion Bar)) >> Removal & Installation >> Stabilizer Bar >> Installation

Stabilizer Bar: Installation

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 1993 Oldsmobile Bravada, 1993 GMC Yukon, 1993 GMC Suburban, 1993 GMC Sonoma, and 1993 GMC Safari. However, it is still accessible from the selected car via links, so may be relevant.
  1. Unload torsion bar tension. See Figure . Count exact number of tool turns for reassembly reference.
  2. To install, reverse removal procedure. Install NEW bushings on stabilizer bar. Ensure split in bushing faces toward front of vehicle. Tighten bolts and nuts to specification. See appropriate TORQUE SPECIFICATIONS  table at the end of this article. Lower vehicle. Check wheel alignment and adjust ride height. See SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT.
scientia non olet · About LEMON Manuals