LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1993 >> C3500 HD 6.5 F, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Suspension - Front (4WD & AWD Torsion Bar)) >> Removal & Installation >> Lower Control Arm >> Installation (All Models)

Installation (All Models)

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 1993 Oldsmobile Bravada, 1993 GMC Yukon, 1993 GMC Suburban, 1993 GMC Sonoma, and 1993 GMC Safari. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse removal procedure. Install front leg of lower control arm onto vehicle, then rear leg. Install lower control arm pivot bolts, washers and NEW nuts, with bolts heads facing forward on Astro, "K" Series Blazer & Pickup, Safari, Sierra, Suburban and Yukon. Pivot bolt heads should be installed facing rear on Bravada, Jimmy, Sonoma, Typhoon and "T" Series Blazer & Pickup.
    CAUTION: When installing upper ball joint stud nut, tighten nut to align cotter pin hole. DO NOT tighten ball joint stud nut more than an additional 1/6 turn to align cotter pin hole. Complete tightening of upper ball joint stud nut with vehicle at proper riding height specification.
  2. Tighten bolts and nuts to specification. See appropriate TORQUE SPECIFICATIONS  table at the end of this article. Lower vehicle. Check wheel alignment and adjust ride height. See SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT. Complete tightening of lower control arm pivot bolts and nuts with vehicle at proper riding height specification.
scientia non olet · About LEMON Manuals