LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1992 >> Forward Control 5.7 K, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Overhaul >> HARRISON Hr100T & Hr110T 4-CYL >> Shaft Seal >> Removal

Shaft Seal: Removal

  1. Discharge A/C system using approved refrigerant recovery/recycling equipment. Using Clutch Plate Spanner (J-33027-A), remove crankshaft nut. Thread Clutch Plate Remover (J-33013-B) into clutch plate. Hold body of clutch plate remover. Tighten center bolt to remove clutch plate. Remove crankshaft key. See Figure .
  2. Remove shaft seal snap ring. Ensure seal area on compressor is clean. Insert Shaft Seal Remover/Installer (J-23128-A) into shaft seal.
  3. Rotate handle clockwise, and remove shaft seal. Using "O" Ring Remover (J-9553-01), remove "O" ring.
scientia non olet · About LEMON Manuals