LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1992 >> Forward Control 5.7 K, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Overhaul >> HARRISON Hr-6/Hr-6-He 6-CYL & V5 5-CYL >> Shaft Seal >> Installation

Shaft Seal: Installation

  1. With shaft seal protector in place, lubricate new "O" ring with refrigerant oil, and install it on "O" Ring Installer (J-33011).
  2. Insert "O" ring installer in compressor until it bottoms. Move slide on "O" ring installer downward until "O" ring is released into groove. Rotate installer to seat "O" ring. Remove "O" ring installer.
  3. Lubricate shaft seal with refrigerant oil. Expand seal using shaft seal remover/installer. Install seal on Seal Protector (J-34614). Place seal protector over shaft. Push shaft seal into compressor using a rotary motion until seal bottoms.
  4. Install NEW snap ring with flat side against seal. Install clutch plate on compressor crankshaft.
  5. Using clutch plate remover/installer, press clutch plate onto compressor until a clutch assembly clearance of .020-.030" (.51-.76 mm) is achieved.
  6. Using spanner, install crankshaft nut and tighten it to 12 ft. lbs. (16 N.m). Evacuate and recharge system. Check for leaks.
scientia non olet · About LEMON Manuals