LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1992 >> Forward Control 5.7 K, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C Compressor Overhaul >> HARRISON Hr-6/Hr-6-He 6-CYL & V5 5-CYL >> Clutch Assembly >> Removal

Clutch Assembly: Removal

  1. Using Clutch Plate Spanner (J-25030) for HR-6 and HR-6-HE compressors or (J-33027-A) for V5 compressor, hold clutch plate and remove crankshaft nut. Use Clutch Plate Remover/Installer (J-33013-B) to remove clutch plate. See Figure and Figure .
    CAUTION: DO NOT drive on compressor shaft to remove clutch plate, or compressor damage will result.
    Fig 1: Exploded View of Harrison HR-6 & HR-6-HE Compressor
    G104024Courtesy of GENERAL MOTORS CORP.
    Fig 2: Exploded View of Harrison V5 Compressor
    G104025Courtesy of GENERAL MOTORS CORP.
  2. Remove key from shaft. Remove snap ring. Install Guide (J-33023-A) on front head. Position Puller (J-33020) in slots on pulley assembly. Tighten puller and remove pulley assembly.
  3. Use hammer and Bearing Remover (J-9398-A) to drive bearing from pulley. Disconnect clutch coil electrical wiring.
  4. Scribe reference marks on compressor and clutch coil for installation reference. Remove clutch coil using Puller Adapter (J-33023-A) and 2-jaw puller.
scientia non olet · About LEMON Manuals