LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1992 >> Forward Control 5.7 K, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 4.3L V6 - VINS [W,Z] (Including SYCLONE) >> Removal & Installation >> Rear Crankshaft Oil Seal >> Installation

Rear Crankshaft Oil Seal: Installation

  1. Lubricate inner and outer diameter of seal with engine oil. Place seal on Seal Installer (J-35621). Position seal installer against crankshaft.
  2. Thread attaching screws into crankshaft flange and tighten with screwdriver. This squares seal with crankshaft. Rotate seal installer handle until it bottoms. Remove seal installer. Install flywheel, clutch (M/T) and transmission.
scientia non olet · About LEMON Manuals