LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 96 (Engine Controls - System/Component Tests - 3.8L) >> Engine Sensors & Switches >> Crankshaft Position (CKP) Sensor

Crankshaft Position (CKP) Sensor

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, 1995 Dodge Caravan, and 1995 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
  1. CKP sensor is located in transmission bellhousing near drive plate. Connect lab type oscilloscope to sensor output wire at CKP sensor connector (Gray/Violet wire).
  2. With CKP sensor connector connected, start or crank engine. The output voltage of a good CKP sensor should switch between about 5.0 volts and about 0.3 volt. See Figure . If output voltage does not fluctuate between 0-5 volts, check Red wire at CKP sensor connector for 8-volt reference voltage. Ensure good ground exists on Black/Light Blue wire at CKP sensor connector
scientia non olet · About LEMON Manuals