LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Engine Controls - System/Component Tests - 3.3L Gasoline) >> Relays >> Auto Shutdown (ASD) Relay

Auto Shutdown (ASD) Relay

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, and 1995 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.
  1. ASD relay is located in engine compartment. Relay terminal numbers are stamped on bottom of relay. Relay must be disconnected for testing. If any of the following resistance and continuity tests fail, replace relay.
  2. Using an ohmmeter, measure resistance between terminals No. 85 and 86. Resistance should be 70-80 ohms.
  3. Connect ohmmeter between terminals No. 87A and 30. Continuity should exist. Connect ohmmeter between terminals No. 87 and 30. Continuity should not exist.
  4. Using a pair of jumper wires, connect a jumper wire between terminal No. 85 and battery ground. Connect other jumper wire to battery positive terminal, but DO NOT connect to relay yet.
    CAUTION: DO NOT allow ohmmeter to contact terminal No. 85 or 86 during following test. Damage to ohmmeter may result.
  5. Attach other jumper wire to relay terminal No. 86 to activate relay. Continuity should exist between terminals No. 87 and 30, but not between terminals No. 87A and 30. Disconnect jumper wires from battery and relay.
scientia non olet · About LEMON Manuals