LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Air Bag Restraint System) >> Removal & Installation >> CLOCKSPRING >> Removal

Removal & Installation: CLOCKSPRING: Removal

WARNING: This page is about a different car, the 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. If replacing a deployed air bag, clockspring must be replaced. Before proceeding, see SERVICE PRECAUTIONS  . Set steering wheel and front wheels in straight ahead position. Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM  .
  2. Remove air bag module and steering wheel (to access clockspring). See DRIVER-SIDE AIR BAG MODULE & STEERING WHEEL  . Disconnect horn connector. Remove cruise control switch, connector, and upper/lower steering column shrouds (to access clockspring wiring).
  3. Disconnect Yellow 2-way clockspring harness connector, between clockspring and instrument panel wiring harness, at base of steering column.
  4. Remove clockspring by releasing 2 tabs on side of clockspring. Clocksprings cannot be repaired and must be replaced if faulty.
scientia non olet · About LEMON Manuals