Blade & Sealed Pin Terminals

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, 1995 Dodge Caravan, and 1995 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.

Remove terminal wedge lock. Insert appropriate tool at location "A". See Fig 1 and Fig 2 . Gently pry plastic locking finger away from terminal. Pull gently on wire until terminal releases.

Fig 1: Removing Blade & Sealed Male and Female Pin Terminals
Courtesy of CHRYSLER CORP.

Fig 2: Removing Blade & Sealed Pin Terminals
Courtesy of CHRYSLER CORP.
To install terminal, push terminal into its cavity until click is heard. Pull wire lightly to ensure terminal is locked. Reinstall terminal wedge lock. On sealed pin terminals, always reinstall seal after repairs. Replace defective terminals. See REPLACING TERMINALS.