LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (3.8L V6 Gas - VIN [L]) >> Overhaul >> Cylinder Block Assembly >> Fitting Pistons

Fitting Pistons

WARNING: This page is about a different car, the 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, and 1995 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure piston diameter at 1.42" (36.0 mm) from top of piston at 90-degree angle to piston pin. Measure cylinder bore diameter at .50" (12.7 mm) below top surface of cylinder bore, middle of bore and .50" (12.7 mm) from bottom of cylinder bore.
    NOTE: Piston diameter and cylinder bore should be measured at room temperature of approximately 70°F (21°C).
  2. Ensure piston diameter and clearance are within specification. See PISTONS, PINS & RINGS SPECIFICATIONS  table under ENGINE SPECIFICATIONS.
scientia non olet · About LEMON Manuals