LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (3.3L V6 CNG - VIN [J]) >> Overhaul >> Cylinder Block Assembly >> Thrust Bearing

Thrust Bearing

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, and 1995 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Thrust bearing is located on No. 2 main bearing. Replace thrust bearing if crankshaft end play is not within specification. See CRANKSHAFT, MAIN & CONNECTING ROD BEARINGS SPECIFICATIONS  table under ENGINE SPECIFICATIONS.
  2. To obtain correct thrust bearing alignment, install all main bearing cap bolts finger tighten. Tighten the main bearing cap bolts to specification on No. 1, 3 and 4 main bearing caps. Refer to TORQUE SPECIFICATIONS .
  3. Pry crankshaft toward rear of cylinder block, and then back toward front of cylinder block. Hold crankshaft in forward position. Tighten main bearing cap bolts to specification on No. 2 main bearing cap.
scientia non olet · About LEMON Manuals