LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1991 >> Value Van 7.4 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (3.3L V6 CNG - VIN [J]) >> Overhaul >> Cylinder Block Assembly >> Cylinder Block

Cylinder Block

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, and 1995 Dodge Caravan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check cylinder bore, out-of-round and taper. Measurements should be taken at .50" (12.7 mm) below top surface of cylinder bore, middle of bore and .50" (12.7 mm) from bottom of cylinder bore.
    NOTE: Cylinder bore should be measured at room temperature of approximately 70°F (21°C).
  2. Replace cylinder block if not within specification. See CYLINDER BLOCK SPECIFICATIONS  table under ENGINE SPECIFICATIONS. Cylinder block deck surface warpage information is not available from manufacturer.
  3. Check valve lifter bore diameter and for signs of scoring. If scoring exists or lifter bore diameter is not within specification, ream cylinder block bore for next oversize valve lifter. Refer to VALVE LIFTERS SPECIFICATIONS  table under ENGINE SPECIFICATIONS. Oversize valve lifters are available in .001" (.02 mm), .008" (.20 mm) and .030" (.76 mm) sizes.
scientia non olet · About LEMON Manuals